The XIP driver is used to transfer program via ethernet to premium PLCs with an ethernet port onboard (For example TSX P573623A)This method is MUCH FASTER than via the serial cable.This step is OPTIONAL if you do not intend to program via an ethernet cable, you can skip this part.However, a valid ethernet configuration must already be on the PLC, meaning you cannot program an empty card with this method, for that you must still use the serial cable.Personally, I have a small program with just a hardware configuration that contains just an ethernet setup and nothing else.I download this to the PLC via the serial cable, and when the download is complete and the ethernet module is initialized, I download the large program via the ethernet cable.
Pl7 Pro V4 5 Download 24
Download Zip: https://byltly.com/2vJSDz
2ff7e9595c
Opmerkingen